How to solve RF Communication failure on Hitachi Air Conditioner?
If your Hitachi Air Conditioner shows 'RF Communication failure', check the RF communication setup. This issue occurs when there is no communication for 1 hour with one or two RF receivers which are bound to the RF-Bridge.
What to do if Hitachi Heat Pump has phase failure?
In case of phase failure or inverted phase order in your Hitachi Heat Pump, reorder the phases.
Why does the Hitachi Heat Pump control circuit fuse blow?
A blown fuse in the control circuit of your Hitachi Heat Pump may be due to several reasons. To resolve this, check for: * Live cables short circuit, or short circuit of the control circuit to earth: Remove the cause of the short circuit and replace the fuse. * Failure of the magnetothermic switch for the compressor or pump: Replace the respective switch and fuse. * Failure of auxiliary relay: Replace the relay and fuse. * Failure of solenoid valve coil: Replace the coil and fuse. * Short circuit in PCB: Remove any particles and replace the fuse. * Oil heater failure or failure of freeze protection heater for water piping: Replace the respective heater and fuse.
What to do if Hitachi Air Conditioner shows Increase in the inverter fin temperature or abnormality?
Check cooling conditions for the inverter.
How to solve Incorrect capacity setting or combined capacity between outdoor and indoor units on Hitachi YUTAKI?
If your Hitachi Air Conditioner displays 'Incorrect capacity setting or combined capacity between outdoor and indoor units', ensure proper capacity settings for both units. This is caused by an incorrect Capacity Code Setting, or Excessive or Insufficient Indoor Unit Total Capacity Code.
What to do if Hitachi YUTAKI shows Failure of discharge gas pressure sensor?
If your Hitachi Air Conditioner displays a 'Failure of discharge gas pressure sensor', check the connectors for any looseness or breakage. The issue may be a loose, disconnected, broken, or short-circuited connector.
What to do if Hitachi Air Conditioner has Receiver Communication failure?
If your Hitachi Air Conditioner is not receiving a signal, check the Opentherm/Hlink connection.
What causes Hitachi Air Conditioner hydraulic alarm pressure?
If your Hitachi Air Conditioner displays 'Hydraulic alarm pressure', check the system for any leaks or blockages affecting water pressure. This alarm indicates that water pressure is not detected in the hydraulic cycle.
How to solve Incorrect indoor unit setting on Hitachi Air Conditioner?
Correct the indoor unit capacity settings.
Why does my Hitachi YUTAKI Air Conditioner activate safety device from excessively high discharge pressure?
If your Hitachi Air Conditioner activates the safety device due to excessively high discharge pressure, inspect the heat exchanger and refrigerant conditions. This activation can be caused by overload (obstruction of HEX, short circuit), a mixture of inert gas, or excessive refrigerant.
Covers critical safety precautions, including danger warnings and cautions for handling the heat pump system.
Emphasizes the importance of reading the manual, verifying installation information, and understanding Hitachi's policies.
Presents nominal capacity and performance data for YUTAKI S models under various operating conditions.
Details Energy-related Product (ERP) performance data for space heaters, including efficiency and energy classes.
Illustrates the operating temperature ranges for space heating, DHW, swimming pool heating, and space cooling.
Outlines essential safety precautions and maximum permitted concentrations for refrigerant leakage.
Lists alarm codes displayed on the remote control switch and their corresponding details for indoor units.
Provides a detailed table of indoor unit alarms, their origin, abnormality details, and main contributing factors.
Details abnormality types and main causes for outdoor unit alarms, categorized by code number and type.
Outlines essential maintenance tasks and precautions for licensed technicians, including power disconnection.
General| Heating Capacity | 5.0 kW - 16.0 kW |
|---|---|
| Cooling Capacity | 5.0 kW - 16.0 kW |
| Energy Efficiency Class | A+++ |
| Refrigerant | R32 |
| Operating Temperature Range (Cooling) | 46°C |
| Noise Level (Indoor Unit) | 45 dB |
| Noise Level (Outdoor Unit) | 45 dB |
To Next Page
