What to do if Hitachi YUTAKI S80 RWH-6.0VNFE shows Failure of discharge gas pressure sensor?
If your Hitachi Air Conditioner displays a 'Failure of discharge gas pressure sensor', check the connectors for any looseness or breakage. The issue may be a loose, disconnected, broken, or short-circuited connector.
What to do if Hitachi YUTAKI S80 RWH-6.0VNFE shows abnormal transmission between outdoor and indoor units?
If your Hitachi Air Conditioner shows 'Abnormal transmission between outdoor and indoor units', check the wiring, terminals, and PCB for faults. This issue can be caused by incorrect wiring, loose terminals, PCB failure, a tripped fuse, or the power supply being OFF.
Why does my Hitachi Air Conditioner activate safety device from excessively high discharge pressure?
If your Hitachi Air Conditioner activates the safety device due to excessively high discharge pressure, inspect the heat exchanger and refrigerant conditions. This activation can be caused by overload (obstruction of HEX, short circuit), a mixture of inert gas, or excessive refrigerant.
How to solve Incorrect indoor unit setting on Hitachi Air Conditioner?
Correct the indoor unit capacity settings.
What causes Abnormality of picking up circuit for protection (Outdoor unit) in Hitachi Air Conditioner?
If your Hitachi Air Conditioner displays 'Abnormality of picking up circuit for protection (Outdoor unit)', inspect indoor unit PCB and wiring. The cause can be a failure of indoor unit PCB, incorrect wiring, or connection to PCB in the indoor unit.
What to do if Hitachi YUTAKI S80 RWH-6.0VNFE Air Conditioner shows Transistor module protection activation?
Inspect the transistor module conditions.
What does Decrease in discharge gas superheat mean for Hitachi YUTAKI S80 RWH-6.0VNFE Air Conditioner?
If your Hitachi Air Conditioner displays 'Decrease in discharge gas superheat', check refrigerant charge and inspect related components. Possible causes are excessive refrigerant charge, failure of thermistor, incorrect wiring, incorrect piping connection, or expansion valve locking at opened position (disconnected connector).
How to solve RF Communication failure on Hitachi YUTAKI S80 RWH-6.0VNFE Air Conditioner?
If your Hitachi Air Conditioner shows 'RF Communication failure', check the RF communication setup. This issue occurs when there is no communication for 1 hour with one or two RF receivers which are bound to the RF-Bridge.
What to do if Hitachi YUTAKI S80 RWH-6.0VNFE Air Conditioner shows Increase in the inverter fin temperature or abnormality?
Check cooling conditions for the inverter.
How to fix Incorrect PCB Setting in Hitachi YUTAKI S80 RWH-6.0VNFE Air Conditioner?
If your Hitachi Air Conditioner shows 'Incorrect PCB Setting', correct the DSW settings. This issue is caused by a wrong DSW setting in the case of Co041.
General| Brand | Hitachi |
|---|---|
| Model | YUTAKI S80 RWH-6.0VNFE |
| Category | Air Conditioner |
| Language | English |
Provides crucial safety precautions and warnings for handling and operating the heat pump system.
Specifies wiring size requirements for outdoor and indoor units based on current and cable types.
Details the location of DIP and rotary switches on the outdoor unit's PCB for configuration.
Illustrates main power supply and indoor/outdoor communication wiring connections.
Details input and output terminal connections for PC-ARFHE, 4-20mA, sensors, and valves.
Guides the user through initial system configuration based on installation type and components.
Details the procedure for purging air from the system, including duration and start command.
Guides through the unit test run process, specifying duration, mode, and start command.
Lists alarm codes displayed on the remote control switch and their detailed abnormalities.
To Next Page