SAFETY
SA-17
SAFETY TRANSPORTING
• The danger of tipping is present when
loading/unloading the machine onto/from a truck or
trailer bed.
• Be sure to observe local regulations when
transporting the machine on public roads.
• Provide an appropriate truck or trailer for
transporting the machine.
Take the following precautions when loading /
unloading the machine:
1) Select firm level ground.
2) Be sure to use a loading dock or ramp.
3) Be sure to have a signal person when
loading/unloading the machine.
4) Always turn the auto-idle / acceleration selector
and the H/P mode switch OFF when loading or
unloading the machine, to avoid unexpected
speed increase due to unintentional operation
of a control lever.
5) Always select the slow speed mode with the
travel mode switches. In the high speed mode,
travel speed may automatically increase.
6) Avoid steering while driving up or down the
ramp as it is extremely dangerous. If steering is
unavoidable, first move back to the ground or
flatbed, modify traveling direction, and begin to
drive again.
7) Do not operate any levers besides the travel
levers when driving up or down the ramp.
8) The top end of the ramp where it meets the
flatbed is a sudden bump. Take care when
traveling over it.
9) Prevent possible injury from machine tipping
while the upperstructure is rotating.
10) Keep the arm tucked under and rotate the
upperstructure slowly for best stability.
11) Securely fasten chain or cables to the machine
frame. Refer to "transporting" chapter in the
operator's manual for details.
S035-E08A-0395
SA-395
To Next Page
Loading...
Need help?
General
