8
ASSEMBLY - ATTACHING THE GRILL
Slide the swing away arm assembly
into your hitch and secure it with
the hitch stabilizer bolt.
A. Pull out and twist the hinge spring lock.
B. Release the slam-latch by pressing
down on the lever.
Swing the arm away from the vehicle and
lock at the 90 degree position for stability.
Place the grill head onto the arm.
Thread the knob into the arm collar clamp.
Do not over-tighten. Slide the cotter pin
through the hole at the end of the bolt.
Tighten the arm collar. Lock the grill head
onto the arm with a padlock. (Not included.)
Tighten the bolt using
a wrench, make sure
to tighten the bolt all
the way through to
the other side of the
hitch, slide the cotter
pin into the bolt.
DO NOT MOVE VEHICLE UNLESS THE
SWING AWAY ARM ASSEMBLY IS
SECURELY BOLTED ONTO THE HITCH.
DO NOT MOVE VEHICLE UNLESS THE
GRILL HEAD IS LOCKED IN PLACE.
1 2
3
4
5
A
B
To Next Page
Loading...