4 5
9 CHANNEL 2.4GHz AIRCRAFT COMPUTER RADIO SYSTEM 9 CHANNEL 2.4GHz AIRCRAFT COMPUTER RADIO SYSTEM
System Menu
MDL Select Create a new model
Select an existing model
Copy one models data into a fresh model memory slot
Reset the model memory to factory default settings
Rename a model
MDL Type Model type menu, ACRO, GLID or HELI
Timer Menu for Timer 1, 2 and the Integral timer
Channel Model control channel assignment menu.
Modulation Select desired modulation type, 2.4, 72 FM or QPCM
TrimStep Size adjustment menu for the trim steps
Trainer Trainer option menu
Power Transmitter power adjustment menu
MODE Stick mode option menu
Info Transmitter ID information
Freq Sel Select the active models transmit channel while in PPM and QPCM only
Sensor Telemetry menu appearing while in 2.4GHz mode only.
Model Menu and more…
Major Super Special Hints
Additional Menus, the Custom and Adjust Features
Adjustment Menu
The Switch Selection Process
Selecting a switch
The Adjust function switch set-up
Additional camber and launch mode adjust function menu (GLID)
Helicopter throttle and pitch curve adjust functions, hover trim and more
Trim link Activation
Cut position set-up
Launch cut switch set-up
Common Model Functions to ACRO, GLID and HELI
EPA End Point Adjustment
D/R & EXP Dual Rates and Exponential (expo) rates
Sub-Trim Servo Sub-trim adjustment
Reverse Servo reversing function
S. Speed Servo Speed feature
Monitor Active model control monitor
P. Mixs Programmable Mixing
FailSafe Servo position FailSafe
Gyro Gyro on/off and Sensitivity Adjustment
47 - - - - -
49 - - - - -
54 - - - - -
56 - - - - -
57 - - - - -
59 - - - - -
60 - - - - -
62 - - - - -
63 - - - - -
64 - - - - -
65 - - - - -
65 - - - - -
67 - - - - -
67 - - - - -
68 - - - - -
71 - - - - -
72 - - - - -
73 - - - - -
74 - - - - -
75 - - - - -
76 - - - - -
77 - - - - -
78 - - - - -
79 - - - - -
79 - - - - -
80 - - - - -
80 - - - - -
81 - - - - -
83 - - - - -
84 - - - - -
Model Menu
HELI Specific Functions
FLT.COND Idle-up and hold / Flight Conditions
P. & T. Curve Pitch curve & Throttle curve adjustment
Needle Carburetor needle function
SWH-THR Swash plate movement to throttle mix
RUD-THR Tail rotor to throttle mix
T. HOLD Throttle hold function
SwashMix Swash plate fine tuning menu
REVO Mix Revolution mix
Gyro Gyro functions
Governor RPM governor adjustment
Model Menu
Common Model Functions to ACRO and GLID
FLT.COND Flight Conditions
Airbrake Airbrake Function and Landing Mode.
ABR- ELE Airbrake to Elevator mix
AIL-RUD Aileron to Rudder mix
ELE-CAM Elevator to Camber mix
RUD-AIL Rudder to Aileron mix
AIL DIFF Aileron Differential feature
AIL- FLP Aileron to Flap mix
CAMBMIX Wing trailing edge mix
FLP CON Flap control mix
V.Tail V-Tail mix feature
AILEVATR Split elevator and aileron inclusion mix
Elevon Elevon or flying wing mix
Fuel Mix Fuel mixture control adjustment ACRO only
Thro.Cut Throttle cut position ACRO only
T.Curve Throttle curve ACRO only
IdleDown Throttle Idle down position ACRO only
B-fly Butterfly or “Crow” mix GLID only
SnapRoll Snap roll function ACRO only
Motor Glider motor control feature GLID only
Launch Launch mix GLID only
Section Four
Section Five
Section Six
Section Seven
86 - - - - -
91 - - - - -
92 - - - - -
94 - - - - -
95 - - - - -
96 - - - - -
97 - - - - -
98 - - - - -
99 - - - - -
100 - - - - -
101 - - - - -
102- - - - -
103 - - - - -
104 - - - - -
105 - - - - -
106 - - - - -
107 - - - - -
108 - - - - -
109 - - - - -
112 - - - - -
113 - - - - -
116 - - - - -
122 - - - - -
123 - - - - -
124 - - - - -
125 - - - - -
126 - - - - -
127 - - - - -
129 - - - - -
130 - - - - -
132 - - - - -
To Next Page
Loading...