Troubleshooting
Problem: None of the LEDs Turn On
The CDA3-35 is not receiving power, or there is a fault with the device.
1 Ensure that you are using the correct power adaptor.
0 Using a power adaptor other than the one that came with your CDA3-35
can damage the CDA3-35.
2 Ensure that the power adaptor is connected to the CDA3-35 and the wall socket
(or other power source) correctly.
3 Ensure that the power source is functioning correctly. Try another outlet or
powerbar. Replace any broken fuses or reset any tripped circuit breakers.
4 Disconnect and re-connect the power adaptor to the power source and the
CDA3-35.
5 If none of the above steps solve the problem, call the Nexicom
Helpdesk.
Problem: One of the LEDs does not Display as Expected
1 Ensure that you understand the LED’s normal behavior (see LEDs on previous
page).
2 Ensure that the CDA3-35’s cables are connected correctly.
3 Disconnect and re-connect the power adaptor to the CDA3-35.
4 If none of the above steps solve the problem, call the Nexicom Helpdesk.
To Next Page
Loading...
Need help?
General
