HEV-1000 User Manual
6) DETECT LEVEL
Users can set the level of UV wavelength from 0 to 100. Only those UV whose wavelength is
above this detect level are overlaid.
Recording
1) Recording
Users can record and save an overlay image in a video file in the internal storage device of
camera.
• Use “Record” button on the top of device to start/pause recording.
• Current time and Photon Count are also recorded together after Imprinting.
• Recording format is AVI and its compression form is H.264.
• You can designate where to save recordings in SETTING -> STORAGE.
• Recordings will be organized by date in dated folders.
2) Recording method
Recordings can be made in two ways:
• Manual recording
- User manually starts and finishes the recording.
- Change the recording file name: SERIALNO_YYMMDD_HHMMSS_Manual.avi
• Event recording.
- Recording starts 3 seconds before the event and finishes 3 seconds after the event (ESD).
- When another ESD occurs during recording of event, your recording will be finished 3
seconds after the last event.
- Change the recording file name: SERIALNO_YYMMDD_HHMMSS_Event.avi
- Log file: Save the photon count and voltage value at the moment of the event in a file.
- Change the log file name: SERIALNO_YYMMDD_HHMMSS_Event.log
To Next Page
Loading...