12
Pairing your Hub and thermostat
1
At this point check the Hub is
flashing yellow – this means it’s
ready to connect
If it is showing a solid yellow light, unplug
the power to the hub and plug it back in.
By disconnecting the Hub from the power and
then reconnecting it, the Hub should then begin
to flash yellow and be ready to connect.
2
After you have connected all of the
appropriate wires and the body of the
thermostat is attached to the backplate,
you may turn the power back on to your
heating and cooling system using your
electrical breaker box
The thermostat display will show ‘Search’ –
meaning it’s searching for the Hub. A timer will show how long the
thermostat has been searching.
If this lasts for longer than five minutes, contact Hive Technical
Support and they will diagnose any problems.
To Next Page
Loading...
Need help?
General
