17
Stand-alone mode
To remotely control your heating and cooling with Hive the
thermostat and Hub need to be installed at the same time. When
this service isn't available, the thermostat can also be installed
without a Hub. This is known as ‘stand-alone’ mode. In ‘stand-
alone’ mode the thermostat acts as a standard programmable
thermostat without the remote heating and cooling control
features and functionality of Hive.
Using stand-alone mode
1
Upon powering up the thermostat for the
first time, the thermostat display will
show ‘Search’.
2
Push and hold the back and check
buttons until the 10 second timer runs down.
Search...0:23
To Next Page
Loading...
Need help?
General
