HiWeigh KPC - Calibration

6
7
Press
Press1
Press1
 10
AutP
 10
 1
 11
Ones place digit (the 0 of 10) represents the option of
automatically power off function or not.
Ones place0:No automatic power off function
Ones place1:Automatic power off
Tens place digits (the 1 of 10) represents zero tracking
range (1~9):
1:0.4 d 2:0.8 d 3:1.2 d 4:1.6 d
5:2 d 6:2.4 d 7:2.8 d 8:3.2d 9:3.6 d
Also Tens place represents the zero range upon power
on:
Tens digit0 not zero when power on
Tens digit>0 zero rang is 20F·S when power on
EgAutP11
8
Press
 01
-Adr-
 01
Communication address choseserial continuous
output format
Adr = 00 (weight sending from end, 100.0 = 0.001)
Adr=99 (weight sending from beginning, 100.0 =100.0)
Adr=98 (Amount/Quantity)
Adr=01-97 (serial printing ouput)
9
Press
Press
 2400
bAud
 2400
 4800
Baud Rate chose240048009600
Eg: b=4800
10
Press
 0
P-c
 0
Mode chose when power on
0--Price computing
1--Counting
Eg: 0
11
Press
 2
P-Pt
 2
Decimal point (in total amount window) chose0-4
0---none
1-4----0.0 0.00 0.000 0.0000
Eg: 2
12
Press
 0
End of parameter setting
V. Calibration
After parameter setting, you can start to do calibration according to following steps:
Step
Operation
Display
Note
1
Press
------
SEt
------
Needs password, input 8888 and press
Enter calibration mode