Step 2 — Separate the back cover
A screw‑driven camshaft in the bottom left corner pushes the back cover away
from the phone, creating a gap to begin separating the cover.
With the back cover facing up, use a T3 Torx screwdriver to turn the screw in the
bottom edge counterclockwise until the back cover pops up.
Step 3
Before separating the back cover, note the following:
There's a seam just under the back cover panel. Don't insert your tool here.
Insert your tool completely under the back cover, so it's between the frame
and the underside of the back cover.
Insert an opening pick under the bottom left corner of the back cover and slide it
along the bottom edge to release the clips and separate the adhesive.
You should feel and hear the back cover clips release. If you don't, insert
the pick deeper and try again.
To Next Page
Loading...
