08-4
To remove water
•
The water will be mixed to the desired
temperature according to the position of the
pre-mixing unit.
Emptying the water system
• Use the control panel to switch off the electrici-
ty for the water pump
p
by pressing the main
switch for a longer period of time (4 sec.).
• Open all of the water taps
q
to the centre
setting.
• Hang up the adjustable shower head in the
shower.
• Open the outlet valves
o
on the therme.
• Unscrew the cap on the cleaning port of the
fresh water tank
j
.
• Unscrew the overow pipe
k
in the fresh
water tank.
• Remove the lid of the water tank. Take out
the water pump and hold it up until the water
pipes have emptied completely.
• Check whether the tank, therme, faucets and
pipes have emptied completely. If necessary,
blow out any remaining water in the pipes
using compressed air (max. 0.5 bar).
• Re-insert the overow pipe and the water
pump in the fresh water tank and close the
openings.
• Leave the faucets
q
and the outlet valves
o
open.
Hot water supply
• Use the control panel to switch on the ther-
me. The temperature of the water is regulated
by means of a thermostat via 230V mains
supply to 55° C.
• The therme will hold approx. 5 litres.
• If you have turned on the heating system, the
water in the therme will also be heated by the
air circulation of the heating; in self-sufcient
mode, it will be heated solely in this manner.
Rules for the therme
• Use the control panel to switch off this equip-
ment whenever the camper is not in use.
Plan for warm water supply
8
7
6
6
To Next Page
Loading...
Need help?
General
