10-3
• If the ame extinguishes again, re-ignition
takes place during the closing phase of the
fusible cut-out of the ignition safety switch
(approx. 30 seconds).
• If no ame is ignited, the automatic ignitor
k
will continue to work until the operation
handle
j
is switched to “0”.
2
1
Changing batteries on the automatic
ignitor
k
If you cannot hear any ignition sparks or only
hear them in intervals of more than one second,
then you must insert a new battery.
• Ensure that the heating has been switched
off.
• Remove the radiator cover (see Truma opera-
ting instructions).
• Push the cover of the battery compartment
up and exchange the battery (take special
note of plus and minus).
• Close the battery compartment.
• Use only a temperature-resistant (+70° C) and
leakproof mignon battery.
During initial operation of the heating
system, there will be a slight nui-
sance caused by smoke and odours.
Immediately turn the operating
handle
j
on the heating to position
„10“ and set the circulation fan to the
highest position. Open all doors and
windows and air the camper well.
The smoke and odours will disperse
after a short while.
To shut off
• Turn the operation handle
j
to position "0".
The automatic ignitor is thereby shut off.
• If necessary, let the circulation fan continue to
run for a while.
• Close the bottle valve and the quick-close
valve if the unit is not used for a longer period
of time.
Insert new batteries before the begin-
ning of each heating season.
Also note the separate operating
instructions from the manufacturer.
To Next Page
Loading...
Need help?
General
