Need help?Do you have a question about the Hobie 14 Turbo and is the answer not in the manual?
Connects the bow tangs to the mast for primary support.
Components for rolling and unrolling the jib sail.
Provide lateral stability to the mast.
Connects the jib luff to the front of the mast.
Wires for crew to hang from when hiking.
Lines used to adjust the length of trapeze wires.
Elastic cord to retract trapeze handles.
Devices to secure rope tension.
Small connecting hardware for rigging.
Wire that supports the jib blocks on the trampoline.
Pulleys used for running the jib sheet.
The line used to control the jib sail.
Blocks attached to the clew of the jib.
The sail for the front of the boat.
Notes kit compatibility with 1982+ models and upgrade requirements.
Specifies the mandatory use of a dolphin striker kit.
Highlights the necessity of a teflon disc mast step bearing.
Ensures the jib tack thimble fits the furler correctly.
Warns against stepping the mast near overhead power lines.
Connects bridle wires to the bow tangs.
Attaches the furling assembly to the bridle ends.
Secures the support wire under the trampoline.
Attaches forestay, shrouds, and trapeze wires to mast.
Connects the jib head to the forestay swivel.
Connects trapeze components, shock cord, and rope locks.
Adjusts shroud tension using thimbles and adjusters.
Attaches jib blocks, clew blocks, and routes the jib sheet.
Connects the jib furling line to the crossbar and hiking strap.
Performs final rigging checks and demonstrates jib furler operation.
To Next Page
General
