Hobie 15 Club User Manual

www.hobiecat.com
Ref : OM_H15CLUB Issued by : SD Date : 12/2014 UPDATE : 1 Page : 19/27
E
U
R
O
P
E
19
Hobie Cat® Europe
Assembly manual - Hobie 15 CLUB
PREPARATION DU MAT
1. Attach the bridles
Unroll the bridles fixed on the hulls. Take the stay adjus-
ter with the 6 mm shackle and attach the bridles to it
using the shackle.
If you have the jib furler option, attach the two bridles
onto the furler as shown on the photo.
Roll the jib furler line into the drum. Leave enough line
to cleat it on the front crossbar.
NB : make sure the drum hole on the furler is facing
towards the front of the boat.
2. Shroud stay adjusters
Check that the shroud anchor bars are correctly tightened in
the hulls. Then attach to them the two stay adjusters using
the pins, the split rings and toggles supplied.
3. Mast foot
Take off the bolt that is on the mast base. Insert the pivoting
system of the mast on the mast foot and insert the bolt again
in the mast base. This will prevent the mast from sliding out
of the foot when stepping the mast.
With jib furler
Without jib furler

Hobie 15 Club Specifications

General

Brand	Hobie
Model	15 Club
Category	Boat
Language	English