EN © 2022 HOFFEN. All rights reserved Tower fan
18
MOUNTING THE DEVICE
Remove all parts of the set from the packaging. Check each component for damage.
Connect both parts of the fan base (4) as shown below:
Pass the power cord (3) through the hole in the base and
attach the base to the bottom of the fan (2). Screw the base
to the fan using the mounting screws (5) and a screwdriver
with Phillips head (not supplied) as shown in the adjacent
illustration. v Route the fan's power cable in the channel on
the underside of the base. This will allow the fan to stand
firmly on flat surfaces.
When dismantling, unscrew the base and detach it from the
fan, then disconnect the base parts. The dismantled appliance should preferably be
placed in its original packaging for storage or transport.
All operations should be carried out gently so as not to damage the components.
SWITCHING THE DEVICE ON AND OFF
Make sure your hands are dry before operating the unit.
Mounted and properly prepared and placed device should be plugged into a power
outlet. To switch the fan on/off touch the ON/OFF button (10) on the housing or press
it on the infrared remote control pointing towards the device. The use of the buttons is
confirmed by a short beep.
To Next Page
Loading...
