EN © 2022 HOFFEN. All rights reserved Tower fan
20
REPLACEMENT OF INFRARED REMOTE CONTROL BATTERIES
Use your fingernail to unlock the battery tray. Slide out the battery tray. Remove the
used battery and replace it with a new one (button, CR2025 3V ⎓) as indicated by +
and - on the remote case. Plus is situated on the flat side of the battery. Insert the tray
until the safety catch snaps into place.
In case of any problems with the device, please refer to the following tips.
The device does
not switch on
Check the correct connection to the power supply.
Check whether the electrical outlet is damaged - select another
one.
If you are trying to turn on the device with the remote control,
make sure that the battery is not discharged, that the
transmitter from the remote control points towards the panel of
the device or that the distance between the remote control and
the device is not too large (ca. 5 m).
During the initial period of use, post-production odour may be
emitted from the device. This is a normal situation and the smell
will stop after a certain, not too long time.
If the smell is strong and resembles burning, immediately turn
off the device and disconnect it from the power supply and
contact the manufacturer's service department.
The device works
louder than usual.
Disconnect the unit from the mains before performing the
following operations.
Check for blockages in the fan.
Check that there is no blockage in the air inlet or outlet.
If the problem persists, contact the manufacturer's service department.
STORAGE OF EQUIPMENT
If you are not going to use the device for a long time, after turning it off with the power
button, cleaning it, store it in a dry room away from heat and moisture sources. It is
best to place the device in its original packaging, away from children and pets.
TRANSPORT OF THE DEVICE
When handling, only carry the unit after it has been switched off, holding it by the
handle. Do not expose the device to high temperatures or moisture.
It is recommended to transport the device in its original packaging. Do not expose the
unit to excessive vibration or shock during transportation.
11. STORAGE AND TRANSPORT
To Next Page
Loading...