Hohem iSteady XE - Mounting and Balancing the Gimbal

6
Mounting and Balancing the Gimbal
Expand the iSteady XE.
Tighten the knob by turning it clockwise.
The gimbal would not function properly if the knob
was not tightened.
Make sure that the phone camera is on the left side
of the clamp. Insert your mobile device by putting it
stuck in the bottom of phone clamp and pulling the
top side of the clamp to clip it into place.
Ensure your phone is centrally clamped to the rubber
pads, otherwise the gimbal would vibrate or turn off
automatically.
Slide the phone and keep it clamped and balanced
centrally before powering on.