Holtek HT66F30 - E-ICE Introduction; E-ICE Naming Rules

e-ICE User’s Guide
3
e-ICE User’s Guide
e-ICE Introduction
The e-ICE is Holtek’s new generation MCU hardware emulator which provides
considerable enhancements over its predecessors. Some features include:
 Uses a Real Chip structure to provide simulation results much closer to that of an
actual MCU device
 Can setup up to 64K of easily adjusted breakpoints
 Simulation hardware can be powered using a variable power supply with a range of
2.2V~5.5V allowing pin voltage levels to be compatible with actual device.
 Simplified emulator circuitry, facilitates easier maintenance and greater stability
 Uses a USB interface for PC communication with greater ease of use
e-ICE Naming Rules
The e-ICE is comprised of an MEV Board, DEV Board and Peripheral Board. The
following is the naming rules for each part:
 MEV Board Part No. Naming Rule
Naming Rules have six digits, e.g. M1001C M 1 001 C
type code No. version
 DEV Board Part No. Naming Rule
Naming Rules have six digits, e.g. D1001C D 1 001 C
type code No. version
 Peripheral Board Part No. Naming Rule
Naming Rules have six digits, e.g. P1001B P 1 001 B
type code No. version