SAFETY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at Seite 11
Universalbiegemaschine UB 70, UB 100, UB 100A
9 SAFETY
9.1 Intended Use
The machine must only be used for its intended purpose! Any other use is deemed to be a case of
misuse.
To use the machine properly you must also observe and follow all safety regulations, the
assembly instructions, operating and maintenance instructions lay down in this manual.
All people who use and service the machine have to be acquainted with this manual and must be
informed about the machine's potential hazards.
It is also imperative to observe the accident prevention regulations in force in your area.
The same applies for the general rules of occupational health and safety.
The machine is used for:
Cold and warm bending of flat, round, square bar steel or aluminium or similar material.
Any manipulation of the machine or its parts is a misuse, in this case HOLZMANN-
MASCHINEN and its sales partners cannot be made liable for ANY direct or indirect
damage.
Even when the machine is used as prescribed it is still impossible to eliminate certain residual risk
factors.
9.2 Security instructions
Missing or non-readable security stickers have to be replaced immediately!
The locally applicable laws and regulations may specify the minimum age of the
operator and limit the use of this machine!
To avoid malfunction, machine defects and injuries, read the following security instructions!
Keep your work area dry and tidy! An untidy work area may cause
accidents. Avoid slippery floor.
Make sure the work area is lighted sufficiently
Work in well ventilated area and collect the machine with a dust
collector!
Always stay focused when working. Reduce distortion sources in
your working environment. The operation of the machine when
being tired, as well as under the influence of alcohol, drugs or
concentration influencing medicaments is forbidden.
Only one person shall operate the machine.
The machine must be operated only by trained persons (knowledge
and understanding of this manual), which have no limitations of
motor skills compared with conventional workers.
Do not allow other people, particularly children, to touch the
machine or the cable. Keep them away from your work area.
Wear suitable work clothes! Do not wear loose clothing or jewelry
as they might be caught and cause severe accidents!
To Next Page
Loading...