3
Heating on full power with swing Heating on full power
The default setting temperature is 23°C when the light °C is off
FAN and HEATING (ONLY by remote control)
- Press to switch on the appliance.
- Press to select one of the following modes :
Fan without heating Heating on half power
Heating on full power with swing Heating on full power
- Press again to switch off the appliance.
Stops by going into standby
(the fan stops30 seconds after the stand-by).
- Press to switch on the appliance.
- Press + or - to set the setting temperature from 10°C to 49°C
(the light °C is on). If room temperature
15°C, setting temperature 25°C, the display as the picture
- Press to cancel the temperature setting
(the light °C is off) and to choose the heating on half power ( ) or full power ( ).
The heater working on full power when the room temperature is 4°C lower than the
setting temperature.
.The heater working on half power when the room temperature is between 0° and 2°C
lower than the setting temperature.
The heater switches off when the room temperature is higher than the setting
temperature. the fan working 30 seconds to make inside cool to protect component,
then fan stop, the unit enter into standby.
.The heater switches on again when the room temperature falls 2°C below the setting
temperature.
EN
To Next Page
Loading...
