HOMCOM 823-005V70 User Manual

29
7. TROUBLESHOOTING
Symptom
Inspection
Solution
The unit is
not
operating.
✓ Check the power
connection in securely.
➢ Insert the power cord
securely into the wall Outlet.
✓ Check if the water level
indicator lights up?
➢ Empty the drain pan by
remove the rubber plug.
✓ Check the room
temperature.
➢ The range of operating
temperature is 5-35℃.
The unit
works with
reduced
capacity.
✓ Check the air filter for dirt.
➢ Clean the air filter as
necessary.
✓ Check if the air duct is
blocked.
➢ To clear the obstacle.
✓ Check if the room door or
window is open.
➢ Keep the door and windows
closed.
✓ Check if the desired
operating mode is selected
and the temperature is
properly set.
➢ Set the mode and
temperature at proper set-
point according the manual.
➢ (refer to page16)
✓ The exhaust hose is
detached.
➢ Make sure the exhaust hose is
securely attached.
Water
Leakage
✓ Overflow while moving the
unit.
➢ Empty the water tank before
transport.
✓ Check if the drain hose is
kinked or bends.
➢ Straighten the hose to avoid a
trap existing.
Excessive
Noise
✓ Check if the unit is securely
positioned.
➢ Place the unit on horizontal
and firm ground.
✓ Check if any loose,
vibrating parts.
➢ Secure and tight the parts.
✓ Noise sounds like water
flowing.
➢ Noise comes from flowing
refrigerant. This is normal.
Error
Codes
E0
✓ Communication faults
between main PCB and
display PCB.
➢ Check the wire harness of the
display PCB for damage.
E1
✓ Ambient temperature
sensor failure
➢ Check connection or replace
it. To clean or replace the
temperature sensor.
E2
✓ Coil temperature sensor
failures.
➢ Check connection or replace
it. To clean or replace the
temperature sensor.
Ft
✓ Condensate water high
level alarm.
➢ Empty the drain pan by
removal the rubber plug.

HOMCOM 823-005V70 Specifications

General

Brand	HOMCOM
Model	823-005V70
Category	Air Conditioner
Language	English