Operating the air cooler
Insert plug to the electrical outlet. Press the “On-Off” button to switch the unit“On”.
The LED indicator automatically shows the room temperature and shifts the fan to
stand by position. The function of the unit can be controlled via on board control
panel or by remote.
1. On/Off：Pressing the “On” button on the control panel or pressing the On/Off
button on the remote control will turn he unit ON at intermediate speed. After few
minutes, the fan will drop to show speed or to the pre-programmed memory
setting. To switch back the standby position, simply press the “Off” button on
control panel or press the “On/Off” button on remote control.
2. Speed: Press this key to choose between high, medium and low fan speed.
Each time the “Speed” button is pressed, an icon will appear on the LED screen
indicating the current speed level.
3. Wind：Press the “Wind” button to choose the type. Indicator light will display the
selected type of wind;
Normal：A continuous wind blow that can be adjusted to low，med and high
speed.
Natural：Nature setting provides a soft and comfortable environment with a
selection of low, medium and high speed.
Sleep：
1.WHEN SPEED HIGH，After 30 minutes of operation in the high-grade state of
natural wind, it will be transferred to the mid-range operation of natural wind, and
after 30 minutes, it will be transferred to the low-grade operation of natural wind,
and then continue to operate in the low-grade state of natural wind.
2.When the wind speed is in the medium range, it shall run in the medium range
of natural wind for 30min, and then turn to the low range of natural wind, and
continue to run in the low range of natural wind.
3.When the wind speed is low, continue to operate in the low natural wind speed.
To Next Page
Loading...
