To Next PageTo Next PageWhat to do if my Home Decorators Collection ASHBY PARK 59252 Fan will not start?
If your Home Decorators Collection Fan won't start, begin by checking the main and branch circuit fuses or breakers. Also, inspect the line wire connections to the fan and the switch wire connections within the switch housing.
How to fix a wobbling Home Decorators Collection ASHBY PARK 59252 Fan?
If your Home Decorators Collection Fan wobbles, first check that all blade and blade arm screws are secure. Most fan wobble problems are caused when blade levels are unequal. Check this level by selecting a point on the ceiling above the tip of one of the blades and measure from a point on the center of the blade to the point on the ceiling. Rotate the fan until the next blade is positioned for measurement, and measure from the same point on each blade to the ceiling. Repeat for each blade, ensuring any measurement deviation is within 1/8 inch. You can also run the fan for ten minutes.
Why is my Home Decorators Collection ASHBY PARK 59252 so noisy?
If your Home Decorators Collection Fan is noisy, make sure all motor housing screws are snug. Check that the screws attaching the fan blade bracket to the motor hub are tight. Also, ensure the wire nut connections aren't rattling against each other or the interior wall of the switch housing. If the fan is new, allow a 24-hour “breaking in” period, as most noises disappear during this time. Finally, ensure your outlet box is secure and rubber isolator pads were used between the mounting plate and outlet box.
General| Brand | Home Decorators Collection |
|---|---|
| Model | ASHBY PARK 59252 |
| Category | Fan |
| Language | English |
Lists the screws and wire connectors provided with the fan for assembly.
Identifies all parts included in the fan package for assembly and installation.
Details how to securely mount the fan's outlet box for safe installation.
Securely attach the fan mounting plate to the outlet box and prepare wiring.
Carefully lift and hang the fan motor assembly onto the mounting plate.
Synchronize the remote control and receiver by setting dip switches.
Connect the fan wires to household wiring using provided connectors.
Install the receiver into the mounting plate bracket.
Securely attach the fan motor assembly to the mounting plate and install trim ring.
Insert fan blades into the motor assembly and secure with screws.
Connect the light kit pan plug and secure it to the fan motor assembly.
Connect light kit wires and attach the fitter assembly to the light kit pan.
Place and secure the glass bowl onto the light kit pan.
Explains how to use the remote control for fan speed, light, and CCT.
Details how to adjust the light color temperature (Warm, Soft, Daylight).
