Home HME020003N - Care and Cleaning

12
The desired cool setting is selected by rotating the knob to the right to the
appropriate location.
HI COOL has maximum cooling effect and airow.
LO COOL has minimum cooling effect and airow.
AIR CONDITIONER FEATURES
CARE AND CLEANING
COOL MODE
THERMOSTAT
FAN MODE
The thermostat is used to set the desired room temperature when the unit is
being operated in the COOL MODE.
To set the desired room temperature, rotate the thermostat switch to the
desired setting. After the set temperature is achieved the thermostat will
automatically start and stop the compressor in order to maintain the desired
set temperature.
Rotate the thermostat selector clockwise for higher cool settings. Higher cool
settings will provide lower room temperature. Rotate the thermostat selector
counter clockwise for lower cool settings. Lower cool settings will provide
higher room temperature.
Clean your air conditioner
occasionally to keep it looking
new. Be sure to unplug the unit
before cleaning to prevent chock
or re hazards.
The air lter should be checked
at least once a month to see if
cleaning is necessary. Trapped
particles in the lter can build
up and cause an accumulation
of frost on the cooling coils.
If you plan to store the air conditioner during the winter, remove it carefully from
the window according to the installation instructions. Cover it with plastic or
return it to the original carton.
• Remove the lter by sliding out from the right-hand side.
• Wash the lter using liquid dishwashing detergent and warm water. Rinse
lter thoroughly. Gently shake excess water from the lter. Be sure the lter
is thoroughly dry before replacing. Or, instead of washing you may vacuum the
lter clean.
• Be sure to unplug the air conditioner to prevent shock or re hazard. The
cabinet and front may be dusted with an oil-free cloth or washed with a cloth
dampened in a solution of warm water and mild liquid dishwashing detergent.
Rinse thoroughly and wipe dry.
• Never use harsh cleaners, wax or polish on the cabinet front.
• Be sure to wring excess water from the cloth before wiping around the controls.
Excess water in or around the controls may cause damage to the air conditioner.
• Plug in air conditioner.
Rotate the knob to the left to select your choice of fan speeds for air circulation.
NOTE: When selecting a fan speed, the compressor will not run.
Unit Control
CAUTION
AIR FILTER CLEANING
WINTER STORAGE
AIR FILTER CLEANING
CABINET CLEANING
NOTE: Never use hot water over 104
O
F to clean the air lter. Never attempt to
operate the unit without the air lter.