Home HME020379N - Adjustable Window Slider Preparation; Hung Window Installation Method; Sliding Window Installation Method; Power Cord Wrap

10 11
Step Three: Preparing the Adjustable Window Slider
1. Based on the size of your window, adjust the size of the Window Slider.
2. If the length of the window requires two window sliders, use the bolt to fasten the window sliders once they are
adjusted to the proper length.
NOTE: 
NOTE: Once the Exhaust Hose assembly and Adjustable Window Slider are prepared, choose from one of the following
two installation methods.
INSTALLATION
OPERATION
INSTALLATION
POWER CORD WRAP
OPERATION
Window Slider A
Bolt
Window Slider B
NOTE: To ensure proper functioning, DO NOT over-extend or bend the hose. To ensure the exhaust system works properly,
make sure that there is no obstacle around the air outlet of the Exhaust Hose (in the range of 500mm).
Type 1: Hung Window Installation
1. Cut Foam Seal A and B strips to the proper lengths and remove the adhesive backing. Attach them to the window sash and frame as shown.
2. Insert the window slider assembly into the window opening.
3. Cut the non-adhesive Foam Seal C strip to match the width of the window. Insert the seal between the glass and the window frame to
prevent air and insects from getting into the room.
4. If desired, install the security bracket with 2 screws as shown.
5. Insert the Window Slider Adapter into the hole of the Window Slider.
Type 2: Sliding Window Installation
1. Cut Foam Seal A and B strips to the proper lengths and remove the adhesive backing. Attach them to the window sash and frame as shown.
2. Insert the Window Slider assembly into the window opening.
3. Cut the non-adhesive Foam Seal C strip to match the width of the window. Insert the seal between the glass and the
window frame to prevent air and insects from getting into the room.
4. If desired, install the security bracket with 2 screws as shown.
5. Insert the Window Slider Adapter into the hole of the Window Slider.
Foam Seal B
(Adhesive type-shorter)
Foam Seal A
(Adhesive Type)
A
B
(if required)
Foam seal C
(Non-adhesive type)
2 Screws
Security Bracket
Foam seal C
(Non-adhesive type)
Foam seal A
(Adhesive type)
Window slider A
Window slider B
(if required)
2 Screws
Security
Bracket
Power Cord Wrap
Attach Power Cord Wrap to back of unit.