10
Installation
5. Connect the water inlet hose (for cold water)
Connect the elbow connector to the dishwasher and the other end
to the water supply, make sure it is fastened tightly in place. Do not
over-tight.
If the water hoses are new or have not been used for an extended
period of time, let the water run to make sure the water is clear
and free of impurities, otherwise the water inlet may get blocked
and the appliance could be damaged.
Electrical connection
• Make sure the socket is compatible with the plug of the
appliance.
• The socket must be able to hold 120V/10A and connect to an
individual properly grounded branch circuit, protected by a 15
or 20 amp circuit breaker.
• Other electric appliance with great power should not use the
same socket with the dishwasher.
6. Connect the water outlet hose
Put the water outlet hose into a drainage hose (with diameter more than 1.6 inches) or into the sink, make
sure the outlet pipe is straight and the height of the end of pipe is less than 39.4 inches.
NOTE:
The connector of the outlet pipe should be tight.
Drain hose hook
sink
Max:39.4in
Min:15.7in
outlet hose
Min:1.7in
To Next Page
Loading...
