17
replace them with the new set (not supplied). It must be replaced in pairs.
- With a suitable slotted screwdriver turn the cap anti-clockwise until the carbon brush is
released, replace the brush and make sure that they locate well and are secured within the
brush retainer.
4. Moving the saw
1. When transporting the saw with xed locations make sure that the saw head is locked in
the lower position.
2. The rotary table handle and the bevel lock knob must all be securely tightened.
3. Use the transportation handle to lift the saw. Do not lift the saw by the switch handle.
To Next Page
Loading...