HoMedics BPW-370BT - User Manual

Questions and Answers

C
Catherine TurnerAug 6, 2025
What to do if HoMedics Blood Pressure Monitor cannot communicate with Bluetooth device?
- C
  Chelsea RileyAug 6, 2025
  If your HoMedics Blood Pressure Monitor (BPM) is unable to communicate with your Bluetooth-enabled device, here are some potential causes and solutions: * Ensure that both devices are paired correctly. * Verify that the Bluetooth function is turned on and the device is in standby mode. * Check that the devices are within an acceptable distance of each other (32 feet/10 meters). * Confirm that you are using a compatible Bluetooth-enabled device, referring to the device specifications. * Try re-inserting the batteries. If the issue persists, consider returning the device to your local distributor or importer.
S
Stacy RayAug 11, 2025
Why HoMedics BPW-370BT does not turn on?
- N
  Nicole TaylorAug 11, 2025
  If your HoMedics Blood Pressure Monitor isn't turning on when you press the START/STOP button, it could be due to the following reasons: * The batteries may be depleted. Replace them with two new “AAA” alkaline batteries. * The batteries might be incorrectly positioned. Ensure they are re-inserted with the correct polarities.
M
Miguel CabreraAug 15, 2025
What to do if HoMedics BPW-370BT Blood Pressure Monitor shows EE measurement error?
- C
  carriewhiteAug 15, 2025
  If your HoMedics Blood Pressure Monitor displays the EE measurement error symbol, or if the blood pressure value appears excessively low or high, consider the following: * Ensure the cuff is wrapped properly and positioned correctly. Then, measure again. * Keep your wrist steady during the measurement, avoiding talking or movement. Then, measure again. * Avoid shaking your wrist while the cuff is on.
J
Jessica VelazquezAug 19, 2025
What does E2 error mean on HoMedics BPW-370BT Blood Pressure Monitor?
- R
  Rebecca YoungAug 19, 2025
  If the E2 error symbol appears on your HoMedics Blood Pressure Monitor, it indicates that the inflation pressure exceeded 300mmHg. To resolve this, switch the unit off and then measure again.
N
Nicole HowellAug 23, 2025
What does E1 error mean on HoMedics BPW-370BT Blood Pressure Monitor?
- W
  williamsthomasAug 25, 2025
  If the E1 error symbol is displayed on your HoMedics Blood Pressure Monitor, it indicates an air circuit abnormality. To attempt to fix this, measure again.
J
Jennifer RandolphAug 27, 2025
What does EP error mean on HoMedics BPW-370BT?
- J
  Jacqueline BautistaAug 28, 2025
  If the EP error symbol appears on the display of your HoMedics Blood Pressure Monitor, it indicates a system error. In this case, measure again.
E
Elizabeth YoungSep 1, 2025
What does E3 error mean on HoMedics Blood Pressure Monitor?
- J
  jthompsonSep 1, 2025
  If the E3 error symbol is displayed on your HoMedics Blood Pressure Monitor, it means there was an error determining measurement data. To resolve this, measure again.