HoMedics LEADER LDRBPA-060 User Manual (English)

Questions and Answers:

P
patriciawrightAug 4, 2025
What to do if EE error appears on HoMedics LEADER LDRBPA-060?
- M
  Mr. Kent Pratt IIIAug 4, 2025
  If you see the EE error symbol on your HoMedics Blood Pressure Monitor, or if the blood pressure reading seems too low or high, it could be due to incorrect cuff placement. Make sure the cuff is wrapped properly and positioned correctly. Also, avoid talking or moving during the measurement; try again while keeping your arm steady. Shaking your arm while the cuff is on may also cause this error.
A
Allison PerryAug 10, 2025
How to fix HoMedics LEADER LDRBPA-060 that won't turn on?
- J
  James PetersonAug 10, 2025
  If your HoMedics Blood Pressure Monitor doesn't turn on when you press the START/STOP button, the batteries may be dead. Replace them with four new AA alkaline batteries. Also, ensure the batteries are inserted correctly, paying attention to the polarities. If they are positioned incorrectly, re-insert them in the correct positions.
A
Ashley ScottAug 16, 2025
What does E1 error mean on HoMedics LEADER LDRBPA-060 Blood Pressure Monitor?
- K
  Kelly BowenAug 16, 2025
  If the E1 error symbol appears on your HoMedics Blood Pressure Monitor, it indicates an air circuit abnormality. This could be due to the cuff tube not being properly plugged into the monitor. Check the cuff connection and then measure again.
A
Alisha WilsonAug 21, 2025
What does E2 error mean on HoMedics Blood Pressure Monitor?
- C
  Carol WhitakerAug 21, 2025
  If the E2 error symbol is displayed on your HoMedics Blood Pressure Monitor, it means the inflation pressure exceeded 300 mmHg. To resolve this, switch the unit off and then measure again.
M
mjamesAug 27, 2025
What does E3 error mean on HoMedics LEADER LDRBPA-060?
- M
  Michael GreenAug 28, 2025
  If the E3 error symbol appears on the display of your HoMedics Blood Pressure Monitor, it indicates an error in determining measurement data. Try taking the measurement again.