How to fix a HoMedics Blood Pressure Monitor with no power?
If your HoMedics Blood Pressure Monitor has no power, it could be due to exhausted batteries or incorrect battery insertion. Replace the batteries with new ones, ensuring they are inserted correctly.
What to do if my HoMedics Salter shows low battery?
If your HoMedics Blood Pressure Monitor indicates low batteries, replace them with new ones.
What to do if my HoMedics Salter Blood Pressure Monitor shows error message EExx?
If your HoMedics Blood Pressure Monitor displays error message EExx, it indicates a calibration error. Try retaking the measurement. If the error persists, it's recommended to contact the retailer or the customer service department for assistance. Please refer to the warranty for contact information and return instructions.
Why does my HoMedics Salter show error message E10 or E11?
If your HoMedics Blood Pressure Monitor displays error message E 10 or E 11, it means the monitor detected motion, talking, or a poor pulse signal during measurement. Relax for a moment, and then measure again.
What does error message E21 mean on my HoMedics Salter?
If your HoMedics Blood Pressure Monitor displays error message E 21, it indicates that the measurement process failed. Relax for a moment, and then measure again.
What to do if my HoMedics Salter Blood Pressure Monitor shows error message E20?
If your HoMedics Blood Pressure Monitor displays error message E 20, it means the device isn't detecting a pulse signal during measurement. Try loosening the clothing on your arm and then measure again.
What does error E1 mean on HoMedics Salter Blood Pressure Monitor?
If your HoMedics Blood Pressure Monitor displays error message E 1, it means the cuff is not secure. Refasten the cuff and then measure again.
Why does my HoMedics Blood Pressure Monitor say error E3?
If your HoMedics Blood Pressure Monitor displays error message E 3, it means the cuff pressure is excessive. Relax for a moment, and then measure again.
What does error code E2 mean on HoMedics Salter?
If your HoMedics Blood Pressure Monitor displays error message E 2, it means the cuff is very tight. Readjust the cuff so it is not too loose or too tight, and then measure again.
Key warnings about adult use, non-diagnosis, medication, unsuitable conditions, cuff pressure, and electromagnetic interference.
Instructions for installing, replacing, and disposing of batteries.
Guidance on maintaining optimal posture for accurate blood pressure measurements.
Information on the IHB feature, its detection mechanism, and when to consult a doctor.
A guide to diagnosing and resolving common problems, error messages, and symptoms with the blood pressure monitor.
General| Irregular Heartbeat Detection | Yes |
|---|---|
| Display | LCD |
| Type | Upper Arm |
| Accuracy (pressure) | +/- 3 mmHg |
| Accuracy (pulse) | ±5% |
| Memory | 60 readings |
| Power Source | 4 AA batteries or AC adapter |
| Average Reading Function | Yes |
To Next Page