What to do if Homelite Blower engine does not reach full speed and emits excessive smoke?
If your Homelite Blower engine isn't reaching full speed and is emitting excessive smoke, the possible cause is a problem with the lubricant fuel mixture, a dirty air filter, or a dirty spark arrestor screen. Use fresh fuel and the correct 2-cycle lubricant mix. Also, clean the air filter.
Why Homelite MightyLite UT08550 engine will not start?
There are several reasons why your Homelite Blower engine might not start: * **No spark:** Check for a spark by removing the spark plug, reattaching the spark plug cap, and laying the spark plug on the metal cylinder. Pull the starter rope and watch for a spark at the spark plug tip. If there's no spark, repeat the test with a new spark plug. * **No fuel:** Push the primer bulb until it is full of fuel. If the bulb doesn't fill, the primary fuel delivery system may be blocked. * **Engine is flooded:** Remove the spark plug and turn the product so that the spark plug hole is aimed at the ground. Rotate the choke dial to the “RUN” position and pull the starter cord 10 to 15 times to clear excess fuel. Clean and reinstall the spark plug. Then, pull the starter three times with the chok...
Procedure to attach the blower tube to the main blower housing.
Procedure to attach the handle to the blower base.
Procedure to attach the vacuum bag to the blower housing.
Procedure to attach the vacuum tubes to the blower.
Details on fuel mixture and safely filling the fuel tank.
Instructions for the safe fueling and refueling of the trimmer.
Detailed instructions for starting and stopping the engine.
Instructions on how to use the blower function safely and effectively.
Instructions on how to use the vacuum function safely and effectively.
To Next Page
General