WARNING: This Engine Starting Procedure is not a substitute for reading
the operator’s manual. To reduce the risk of injury, user must read and under-
stand operator’s manual before using this product.
Slowly press the PRIMER BULB 10x. or until
fuel appears.
Pull starter handle until engine attempts
to start (4X max.)
HOMELITE ART WORK
Art Part No. : 988000-334 Rev. 01
Where Used : 988000-334
Refer to Drawings for Dimensions.
988000-334
10-11-10 (REV:01)
ENGINE STARTING PROCEDURE
Material: 60lb. Stock Paper.
Color: Yellow.
FRONT
TO START:
1
2
3
4
5
SET the throttle to the STOP position.
TO STOP:
Rotate throttle lever to FULL ( ) throttle.
SET choke lever to FULL choke.
6
SET choke lever to HALF choke.
Pull starter handle until engine starts (6X max.)
NOTE: If the unit has not started, return to step 3.
7
8
Allow the engine to warm for 10 seconds,
SET choke lever to RUN.
TO RESTART A WARM ENGINE:
If the engine/unit is already hot:
SET choke lever to RUN.
Pull starter handle until engine starts.
9
2
1
5
7
4
3
6
8
9
50:1 Ratio = Mix 2.6 oz 2-cycle oil with
1 gallon of fresh gasoline in separate gas
container. SHAKE. Pour into fuel tank.
1 GALLON
GAS
2.6
oz.
Make The Most Of Your Purchase!
CALL
1-800-242-4672
www.homelite.com
For any questions about operating or maintaining your product, call the Homelite® Help Line !
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are available in your operator's manual.
Go to www.homelite.com and register your new tool on-line.
Rotate throttle lever to FULL ( ) throttle.
To Next Page
Need help?
General