Homelite UT10549 Repair Sheet

Homelite UT10549

8 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

HOMELITE

UT10549 / 14 in. 35cc CHAIN SAW

UT10569 / 16 in. 38cc CHAIN SAW

UT10589 / 18 in. 42cc CHAIN SAW

(ALL VERSIONS)

REPAIR SHEET

Other manuals for Homelite UT10549

Operator's Manual120 pages

Replacement Parts List8 pages

Questions and Answers:

F
Francisco MitchellAug 11, 2025
How to fix a Homelite UT10549 Chainsaw that starts and runs but won't idle?
- C
  colemanmelissaAug 11, 2025
  If your Homelite Chainsaw starts, runs, and accelerates but won't idle, it might need a carburetor adjustment. Try turning the idle speed screw “T” clockwise to increase the idle speed. If that doesn't work, try turning the idle speed screw “T” counterclockwise to decrease the speed. If the problem persists, contact an authorized service center for a rebuild kit.
K
Kendra PayneAug 21, 2025
Why is my Homelite UT10549 bar and chain running hot and smoking?
- C
  collinssamanthaAug 21, 2025
  Your Homelite Chainsaw's bar and chain might be running hot and smoking due to several reasons: the chain oil tank could be empty (fill it every time you fill the fuel tank), the chain tension might be too tight (adjust it according to the manual's instructions), or the oiler may not be functioning properly. To check the oiler, run the saw at half throttle for 30-45 seconds, then stop it and see if lubricant is dripping from the SAFE-T-TIP® and guide bar. If there's no lubricant, contact an authorized service center. If lubricant is present, the chain may be dull or the bar may be damaged.
M
Mark ConnerAug 31, 2025
What to do if my Homelite UT10549 Chainsaw engine runs but the chain isn't rotating?
- R
  Robert BallAug 31, 2025
  If your Homelite Chainsaw engine starts and runs, but the chain isn't rotating, first check if the chain brake is engaged and release it. If the chain brake is not the reason, the chain tension may be too tight, so adjust it. Also, ensure the guide bar and chain are assembled correctly and inspect them for any damage. If the drive sprocket teeth are damaged, contact an authorized service center for drive sprocket replacement.

Homelite UT10549 Specifications

General

Engine Type	2-Cycle
Bar Length	14 inches
Fuel Tank Capacity	16.9 fl oz
Chain Pitch	3/8 in
Chain Gauge	0.050 inch

Related product manuals

Homelite UT10548

Preview: Homelite UT10540, UT10542

Homelite UT10540, UT10542

UT10548, UT10568, UT10588

Preview: Homelite UT10580

Homelite UT10580

Homelite UT10532

Homelite UT10519

Homelite UT10517

Homelite UT10518

Homelite UT10522

Homelite UT10568

Homelite UT10580,UT10582

Homelite UT10514/14 IN. 33CC