Page 6 of 10
3 Assembly
3.1 Base and Stand
Your Fan has been boxed unassembled to minimise packaging waste. Each part is
designed to fit together and be disassembled easily for cleaning or storage.
• First, unscrew the Locking Lever and Washer from the bottom of the stand post.
• Insert the bottom of the stand post through the hole in the top of the base.
• Tip up so that the underneath of the base is facing the ceiling
• Place the Weight in the centre of the base
• Fasten in place by use of the Locking Lever and Washer and tighten.
3.2 Attach Head to Stand
• Stand the Base and post on the floor.
• Remove the adjustment knob and bolt from the top of the stand post.
• Remove the Small knob and screw from the bracket on the motor housing.
• Sit Motor housing on top of Stand Post and insert large bolt as shown.
• Refit the small knob and screw, but do not tighten the small knob.
• Screw on the Large knob. Adjust the tilt angle to your desired position and then
fully tighten both the small and large knobs.
To Next Page
Loading...
