18
Operation
You can manually start the pairing
mode for another 3 minutes by
pressing the system button (A)
shortly.
•
Your device will automatically ap-
pear in the HomematicIP app.
• To confirm, please enter the last
four digits of the device number
(SGTIN) in your app or scan the QR
code. Therefore, please see the
sticker supplied or attached to the
device.
• Please wait until pairing is comple-
ted.
• If pairing was successful, the LED
(A) lights up green.
• If the LED lights up red, please try
again.
• Select the desired solution for your
device.
• In the app, give the device a name
and allocate it to a room.
After pairing, loads such as electric
heaters can be easily connected to the
pluggable switch. Connected loads can
then be switched on and o.
7 Operation
After pairing and installing have been
performed, simple operations are
available directly on the device.
Press the system button (A) shortly to
switch on and o connected loads.
Improper usage or a defective
installation (e.g. low-quality or
defective plugs or sockets) can
lead to overheating of the plug-
gable switch. The integrated tem-
perature control automatically
switches o the load. The devices
is protected against overheating
and secure operation is ensured.
As soon as the temperature
reaches a non-critical value, you
can switch on the pluggable
switch again. Always observe the
permitted ambient temperature of
the device and, if necessary, have
the installation checked for possi-
ble error sources by an expert.
8 Behaviour after power
recovery
After the device has been inserted to
a socket or after power recovery the
pluggable switch performs a self-test/
restart (approx. 2 seconds). The device
LED (A) flashes orange and green brief-
ly (LED test display). The LED will flash
if an error is detected during this test
(see „9.4 Error codes and flashing se-
quences“ on page 20). This is repea-
ted continuously and the device does
not perform its function. If the test is
completed without errors, the device
transmits a wireless telegram contai-
ning its status information.
To Next Page
Loading...
Need help?
General
