34
Operation
6 Operation
After teaching-in and installing have been performed, simple
operations are available directly on the device.
• Press the system button (A) shortly to switch on and
o connected loads.
Improper usage or a defective installation (e.g.
low-quality or defective plugs or sockets) can
lead to overheating of the pluggable switch. The
integrated temperature control automatically
switches o the load. The devices is protected
against overheating and secure operation is en-
sured. As soon as the temperature reaches a non-
critical value, you can switch on the pluggable
switch again. Always observe the permitted ambi-
ent temperature of the device and, if necessary,
have the installation checked for possible error
sources by an expert.
7 Behaviour after power recovery
After the device has been inserted to a socket or after power
recovery
the
pluggable switch
performs a self-test/restart
(approx. 2 seconds). The device LED
(A)
flashes orange
and green briefly (LED test display).
The LED will flash if
an error is detected during this test (see “8.4 Error codes
To Next Page
Loading...
Need help?
General
