How to set the lower limit:
Allows end user to set minimum height of base if lowest height is not desired
1. Adjust the base to the desired minimum height
2. Press the “M” button, then release
3. Immediately press the “down” button, then release
4. Press and hold the “M” button. The display will flash “555”, then change to display the height
The lower limit (minimum height) is now set
Removing the upper and lower limits:
Allows end user to remove previously determined upper and lower limits to allow for base to reach
highest and lowest limit
1. Hold down the “M” button until the display states “S-“, then release the “M” button
2. Within 5 seconds, hold down the “M” button again for 2 seconds
3. The display will flash “555”, then change to display the height
The upper (maximum height) and lower (minimum height) limits are now removed
How to lock the key pad:
Allows end user to disable key pad from usage if previously enabled
1. Hold the “M” button until the display switches from “S-“ to “LOC”
The control is now locked
How to unlock the key pad:
Allows end user to enable key pad for usage if previously disabled
1. Hold the “M” button until the display switches from “LOC” to the height display
The control is now unlocked
To Next Page
Loading...
