HON HBXRISER - Assembly Steps 3-5; Operating the Unit; Device Placement and Stability; Safety Precautions During Adjustment

1
2
Please do not put hands near the supporting bars,
as they change during adjusting
Warning
When removing equipment, please first
adjust it to the highest, then remove
equipment to avoid harm or damage.
Please move by two persons, or
parts may collide and cause damage.
Please make sure all installed equipment
is on the table, and not sticking out of
the edge, or it may cause harm or damage.
Please leave enough length of cable for
height adjustment function, otherwise it
may cause unexpected loss.
Attention
Attention
Warning
Warning
To raise and lower the unit, put downward pressure on the worksurface
top, and then activate the handle on the front right corner. Upon initial
use, please raise the unit and remove the packing foam inserts from
under the struts.
WARNING
Please do not put hands near the
supporting bars, as they change
during adjusting and may hurt you.
Assembly Step 3
Assembly Step 4
Placedevicesontothetop
oftheworkstation.
CAUTION
Please make sure all installed
equipment is on the table, and do
not hang over table edge as this may
cause harm or damage.
Use the cable management to
guide and bundle the cables
Assembly Step 5
This surface contains adhesive,
helping to fix the cable
management on the table
Cable
Nylon ties
CAUTION
Please leave enough length of cable for
height adjustment function, otherwise it
may cause unexpected loss.
Points
adjustment
0560041300
6/17