Honda CB110C3M - Removing & Installing Body Components; Battery

47
Maintenance
#
Removal
Make sure the ignition switch is in the OFF
position.
1.
Remove the right side cover.
2
P. 51
2. Remove the bolt.
3. Remove the battery holder.
4.
Disconnect the negative terminal from the
battery.
5.
Disconnect the positive terminal from the
battery.
6.
Remove the battery taking care not to drop
the terminal nuts.
#
Installation
Install the parts in the reverse order of removal.
Always connect the positive
terminal first.
Make sure that bolts and nuts are tight.
For proper handling of the battery, see
“Maintenance Fundamentals.”
2
P. 36
“Battery Goes Dead.”
2
P. 86
Removing & Installing Body Components
Battery
Battery holder
Battery
Positive terminal
Negative terminal
Bolt