82
Tyre Puncture
u
Removing Wheels
Installation
1.
Install the side collar into right side wheel
hub.
2.
Position the wheel between the fork legs
and insert the front axle shaft from the
right side, through the right fork leg and
wheel hub.
4.
Tighten the front axle nut.
Torque:
54 N·m (5.5 kgf·m, 40 lbf·ft)
Speedometer cable
Lug
Front axle nut
3. Make sure that lug on the left fork leg is
located in the brake panel.
5.
Install the speedometer cable securely.
6. Install the front and combi brake cables.
7. Install the front and combi brake adjusting
nuts.
8.
Adjust the front brake.
2
P. 6 0
9.
After installing the wheel, apply the brake
lever several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
To Next Page
