84
Tyre Puncture
u
Removing Wheels
Installation
1.
Install the side collars into rear wheel.
2. Place the rear wheel between the
swingarm and install the drive chain over
the driven sprocket.
3.
Insert the rear axle shaft from the left side,
through the left swingarm, wheel hub and
brake panel.
4.
Temporarily tighten the rear axle nut.
5. Reassemble the brake stopper arm and
tighten the stopper arm nut.
6.
Connect the brake rod to the brake arm.
7. Adjust the drive chain.
2
P. 69
8.
Adjust the rear brake freeplay.
2
P. 6 0
9.
Tighten the rear axle nut.
10. Reassemble the drive chain case.
2
P. 4 8
11.
After installing the wheel, apply the brake
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Torque:
22 N·m (2.2 kgf·m, 16 lbf·ft)
Torque:
54 N·m (5.5 kgf·m, 40 lbf·ft)
Drive chain
Drive chain
adjuster nut
Drive chain
lock nut
Rear axle shaft
To Next Page
