(Refer to the maintenance precautions on
page ).
This motorcycle is equipped with a side
stand only. Therefore, if front or rear
wheel removal is required, it will be
necessary to raise the center of the
motorcycle with a jack or other firm
support. If none is available, see your
Honda dealer for this service.
Raise the front wheel off the ground by
placing a support block under the engine.
Disconnect the speedometer cable (1) by
removing the speedometer cable set
screw (2).
1.
2.
(1)(2)
57
(1) Speedometer cable
(2) Speedometer cable set screw
WHEEL REMOVAL Front Wheel Removal
76
03/10/23 11:15:05 32KPF600_082
To Next Page
