1. Set the ENGINE START/STOP
*1
/Ignition Switch
*1
to ON.
2. Press the display/information button repeatedly until the Wrench symbol
is displayed.
3. Press the ENTER button.
4. Press and hold the ENTER button for about 10 seconds to enter the reset
mode.
5. Press the up or down arrows on the selector wheel to select a
maintenance item to reset, or to select All Due Items (You can also
select Cancel to end the process).
6. Press the ENTER button to reset the selected item.
7. Repeat from step 4 for other items you wish to reset.
Failure to reset the engine oil life after a maintenance service results in the
system showing incorrect maintenance intervals, which can lead to serious
mechanical problems.
*1 - If equipped
MAINTENANCE
176 |
Engine Coolant
Park the vehicle on level ground. Check the reserve tank and the coolant level
in the radiator. Use Honda Long Life Antifreeze/Coolant Type 2.
n Checking the Reserve Tank
1. Make sure the engine and radiator are cool.
2. Check the amount of coolant in the reserve tank.
3. If the coolant level is below the MIN mark, add the specified coolant
until it reaches the MAX mark.
4. Inspect the cooling system for leaks.
For vehicles used in temperatures below -31°F (-35°C) , change the coolant
from the standard 50:50 antifreeze:water mix to one with added antifreeze.
Consult a dealer for more information.
MAINTENANCE
| 177
To Next Page
Loading...
Need help?
General
