Honda EU10iT1 - Page 2

2
GENERATOR REMOVAL/INSTALLATION
Remove the shroud (page 13-3).
STATOR
BOLT (5 x 25 mm) (2)
BOLT (6 x 16 mm) (2)
WASHER (6 mm)
NUT (10 mm)
27.5 N·m (2.8 kgf·m, 20 lbf·ft)
BOLT (6 x 16 mm)
COOLING FAN
COOLING FAN BOSS
ROTOR
STARTER PULLEY
GENERATOR WIRE HARNESS
WOODRUFF KEY
(Threads and
seating surface)
REMOVAL/INSTALLATION:
Do not remove the generator wire
harness unless it is replaced.
REMOVAL: page 8-11
INSTALLATION: page 8-12
INSTALLATION:
After installing the rotor, be
sure that the key is set
properly.