50
Engine oil change
If you drain the oil immediately after stopping the engine, its
temperature will be high and may cause burns.
How to change the oil:
If the engine oil is dirty, engine wear will occur more rapidly. Change
the oil at designated intervals. Maintain the oil at the proper level.
OIL CHANGE INTERVAL: Every year, before operation.
RECOMMENDED OIL: Use 5W-30 4-stroke motor oil that meets or
exceeds the requirements for API service
classification SE or later (or equivalent).
Always check the API service label on the oil
container to be sure it includes the letters SE or
later (or equivalent).
QUANTITY SPECIFIED:
1.10
(1.16 US qt , 0.97 Imp qt)
0.60
(0.63 US qt , 0.53 Imp qt)
Fill with new oil up to the upper limit, as indicated by the oil filler
gauge. (In checking the oil level with the oil filler gauge, do not
screw the gauge in.)
After replacing the oil, securely tighten the oil filler gauge.
Place the snowblower on a level surface. Before you drain the oil,
set the snowblower in the HIGT (3) position by operating the height
adjust lever (see page 20 ) (only for track type).
Remove the oil filler gauge and the drain bolt.
Drain the oil while the engine is still warm, to assure rapid and
complate draining.
Install the drain bolt securely.
1.
2.
3.
4.
5.
HS970:
HS760:
07/05/31 14:39:14 3C768600_054
To Next Page
Loading...
