30
Alarm System
(Continued)
Operation Guide
#
Adjusting the Sensitivity of Alarm
System
You can select 3 sensitivity levels of alarm
system.
!a
Turn the ignition switch to the (Off) position.
!b
Repeat the following 3 times:
Turn the ignition switch from the (Off) position
to the (On) position and press SET button on
remote transmitter 2 times.
Then turn the ignition switch from the (On) position
to the (Off) position within 5 seconds.
u You need to operate this process from the
(Off) position to the (On) position
within 5 seconds.
!c Turn and keep the ignition switch to the
(On) position.
Press the SET button to select from 3
sensitivity levels.
3 alarm rings: high sensitivity
2 alarm rings: medium sensitivity
1 alarm ring: low sensitivity
The alarm indicator lights while setting.
!d Turn the ignition switch to the (Off)
position to finish setting the sensitivity level.
To complete your setting, you need to go
through step !c within 60 seconds.
Make sure that remote transmitter LED is
green before setting the sensitivity level.
Because if it is red, you cannot set the
sensitivity level.
LED
(Off)
SET button
(On)
To Next Page
Loading...
