34
Answer Back System
(Continued)
Operation Guide
!c Turn and keep the ignition switch to the
(On) position. Press the ANSWER BACK
button to select among 3 levels of sound
volume or mute.
!d Turn the ignition switch to the (Off)
position to finish setting the buzzer sound
volume level.
To complete your setting, you need to go
through step !c within 60 seconds.
Make sure that remote transmitter LED is
green before setting the buzzer sound
volume level. Because if it is red, you cannot
set the buzzer sound volume level.
#
Changing the Answer Back Buzzer
Sound Pattern
You can select 3 buzzer sound patterns.
!a
Turn the ignition switch to the (Off) position.
!b
Repeat the following 3 times:
Turn the ignition switch from the (Off) position to
the (On) position and press ANSWER BACK button
on remote transmitter 3 times.
Then turn the ignition switch from the (On) position
to the (Off) position within 5 seconds.
u You need to operate this process from the
(Off) position to the (On) position
within 5 seconds.
LED
ANSWER BACK button
(On)
(Off)
To Next Page
Loading...
