41
Operation Guide
Helmet holder
The helmet holder is on the left side below the
seat.
A helmet set wire is in the tool kit.
(P40)
#
Unlocking
Open the lock cover, insert the ignition key
and turn it clockwise.
#
Locking
!a Hang both ends of the helmet set wire that
has been passed through the helmet D-ring
on the holder pin and push it in to lock.
!b
Remove the ignition key and close the lock cover.
u Use the helmet holder only when parked.
Ignition key
Holder pin
Helmet
D-ring
Helmet
set wire
Lock cover
3
WARNING
Riding with a helmet attached to the
holder can interfere with the rear wheel
or suspension and could cause a crash in
which you can be seriously hurt or killed.
Use the helmet holder only while parked.
Do not ride with a helmet secured by the
holder.
To Next Page
Loading...
