Unlock the Ignition Switch in an Emergency
#
Set up to ID number input mode
1.
Check the ID number on the ID tag.
2.
Press and hold the ignition switch for
more than 4 seconds.
u The ignition switch ring and the Honda
SMART Key indicator flash.
3.
Press the ignition switch while the ignition
switch ring and the Honda SMART Key
indicator are flashing.
u The ignition switch ring and the Honda
SMART Key indicator stay lit, and the
ID number input mode turns on.
#
ID number input
You can input your ID number by pressing the
ignition switch when the ignition switch is
(Off), (Lock) or SEAT FUEL position.
Input the ID number on the ID tag in order
from the left in turn by pressing the ignition
switch.
The ID number is authenticated according to
the number of times the ignition switch is
pushed.
Push the ignition switch the desired number
of times within 5 seconds when the ignition
switch ring comes on. After 5 seconds, the
ignition switch ring goes off and comes on
again. This means that the inputted number
is fixed, and you can input the next number.
u
If the ignition switch ring does not come
on in blue, the battery may be low.
Contact your dealer.
Troubleshooting
122
ID number
To Next Page
Loading...
Need help?
General
